Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SmartAssembly 6.1.0.48 - decryption
09-29-2011, 04:39 AM (This post was last modified: 09-29-2011 05:21 AM by zieker.)
Post: #1
SmartAssembly 6.1.0.48 - decryption
I've been messing with a file and have figured out its protected with SmartAssembly 6.1.0.48 from rebeldotnet.

I've used reflector on it and i think I'm lost this is not the standard RE i'm used too.

I'm used to opening things in say IDA or the like and doing my edits.

However this protection thing is a lot more complicated then that.

If someone could point me in the right direction, I'd appreciate it.


Thanks
Find all posts by this user
Quote this message in a reply
09-29-2011, 04:11 PM (This post was last modified: 09-29-2011 04:14 PM by zieker.)
Post: #2
RE: SmartAssembly 6.1.0.48 - decryption
Ok I've run it thru dumbassembly and opened it in reflector, it made it so i could fins the part I want to edit, however I have no idea how it would recompile since i'm pretty sure its missing stuff.

How can I make an edit to the file or decompile it enough to recompile it after i make changes?
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Homepage | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication